Specifications - Dremel 3D40 FLEX Operating/Safety Instructions Manual

DM 2610039151 10-18.qxp_3D40 10/8/18 10:34 AM Page 7
BUILDING
Extruder: Single extrusion
Extruder temperature: Up to 230°C (397° F)
Operating Interface: 3.5" full color IPS touch
screen
Maximum Build Volume: 10" x 6" x 6.7"
(255 mm x 155 mm x 170 mm)
Layer Thickness: 50 microns (0.05 mm)
Filament Colors: For color choices see
www.digilab.dremel.com
Internal Storage: 4 GB
External Storage: USB Flash Drive
WEIGHT & DIMENSIONS
Weight (without spool): 16 kg (35 lbs)
Dimensions: 20.25" x 16" x 15.9"
(515 mm x 406 mm x 394 mm)
FILAMENT
ONLY works with Dremel 1.75 mm filament
FILAMENT STORAGE
All polymers degrade with time. Do not
unpack until filament is needed. Filament
should be stored at room temperature:
16-29° C (60-85° F) and in dry conditions.
SOFTWARE
Dremel 3D40 comes with complimentary
Dremel Digilab 3D Slicer software for
Windows and Mac OSX. This application
converts your 3D digital files into buildable
files.
20.25" (515mm)

Specifications

SUPPORTED OPERATING SYSTEMS
• Apple ® Mac
(Mavericks)
• Microsoft
• Microsoft
MINIMUM SYSTEM SPECIFICATIONS
• CPU: 64-bit processor (32-bit not
supported)
• Memory: 3 GB RAM (4 GB or more
recommended)
• Disk space: ~2 GB free disk space for
installation
• Display card: 1,024 MB GDDR RAM or
more. Microsoft
graphics card or higher
• Pointing device: Three-button mouse
ELECTRICAL REQUIREMENTS
3D40 input rating: 100-240V, 47-60Hz,
OPERATING ENVIRONMENT
Room Temperature: 16-29° C (60 - 85° F)
Level workspace
Dry workspace environment
8" (203mm)
15.5" (394mm)
7
® OS ® X v10.9 or later
® Windows ® 8.1
® Windows ® 7 SP1
® Direct3D ® 11 capable
0.8A-1.8A
WALL
8" (203mm)