Operation - Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow
these instructions exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the ap-
pliance area for gas. Be sure to smell next to
the fl oor because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fi re department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it, call a qualifi ed service technician or gas
supplier. Force or attempted repair may result
in a fi re or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
22

OPERATION

WARNING: If you do not follow
these instructions exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
NOTICE: During initial operation of
new fi replace, burning logs will give
off a paper-burning smell. Open
damper or window to vent smell. This
will only last a few hours.
1. STOP! Read the safety information in column
1.
2. Make sure equipment shutoff valve is fully
open.
3. Set selector switch in OFF position.
WARNING: Burners will come
on automatically within one minute
when the selector switch is in the ON
position after the pilot is lit.
4. Press in and turn control knob clockwise
5. Wait fi ve (5) minutes to clear out any gas.
Then smell for gas, including near the fl oor. If
you smell gas, STOP! Follow "B" in the safety
information, column 1. If you don't smell gas,
go to the next step.
6. Press in and turn control knob counterclock-
wise
control knob for fi ve (5) seconds (see Figure
39, Page 23).
NOTE: You may be running this heater for the
fi rst time after hooking up to gas supply. If so,
the control knob may need to be pressed in for
30 seconds or more. This will allow air to bleed
from the gas system.
CAUTION: Do not try to adjust
heating levels by using the equipment
shutoff valve.
SuperiorFireplaces.us.com
LIGHTING
INSTRUCTIONS
to the OFF position.
to the PILOT position. Press in
126868-01D