Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual page 20

11. Place the top rear log onto the rear log as shown.
The rear log has a projection that will fi t into the
recess area on the bottom of the top rear log (see
Figure 34).
Top Rear Log
Rear Log
Figure 34 - Installing Top Rear Log
EMBER PLACEMENT
If replacement embers are needed,
the replacement embers must be
purchased from IHP - see Page 35
for part numbers.
WARNING: Do not use any other
ember material not supplied with
this unit.
WARNING: Do not operate unit
without ember material correctly
in place as shown in Figures 36 &
37 . Do NOT place ember material
anywhere else on the unit. Use only
ember material supplied with unit.
Excessive or incorrectly placed ember
material may produce carbon monox-
ide or soot.
20
INSTALLATION
Continued
WARNING: ALL PREVIOUSLY AP-
PLIED LOOSE MATERIAL MUST BE RE-
MOVED PRIOR TO REAPPLICATION.
1. Ember Chunk Placement. The VRT4036 series
burner systems include three ember chunks
that are designed to fi t over shoulder screws
on the ember pan burner. The bottom of each
ember chunk has a hole for securing the ember
chunk in place when it is placed over a shoulder
screw. Place the ember chunks as shown in
Figure 35 on Page 21 by placing the ember
chunk with the number "1" on the left, "2" in the
center, and "3" on the right. These numbers are
embossed on the back of each piece for iden-
tifi cation purposes. Please note that VRT4032
series burner systems do not include ember
chunks.
2. Two ember materials are supplied with this log
set. Platinum Bright Embers give a bright glow
appearing as hot coals. Should embers need
replacing, see Parts, Page 33.
Platinum Bright Ember placement. Add em-
bers to front, fl at burner. Gently remove embers
from bag. Separate pieces of ember material
and place on surface of fl at burner just behind
horizontal ports as shown in Figure 36.
Glowing embers (rockwool) placement. Place
glowing embers material on front fl at burner in
areas away from ports as shown in Figure 37.
3. DO NOT place volcanic stone or additional
logs on front burner or on logs. Placing any
material on unit other than ember material on
front burner may result in production of carbon
monoxide or soot.
4. Install fi replace screen by placing the screen
brackets on top of the fi replace screen brackets
as shown in Figure 38. Push the bottom of the
screen inward against the magnetic catches to
secure in place.
SuperiorFireplaces.us.com 126868-01D