Receiving; Contents And Packaging; Installation Tools - YASKAWA MECHATROLINK-II SI-T3 Technical Manual

3 Receiving

3 Receiving
After receiving the option package:
• Make sure that the option is not damaged and no parts are missing.
Contact your sales outlet if the option or other parts appear damaged. Contact your sales outlet if there is
damage to the option or other parts.
NOTICE
Damage to Equipment. Do not use damaged parts to connect the drive and the option. Failure to comply
could damage the drive and option.
• Make sure that the model number on the option nameplate and the model number on the purchase order are the
same. Refer to Figure 4.1
• Contact the distributor where the option was purchased or contact Yaskawa or a Yaskawa representative about
any problems with the option.
◆

Contents and Packaging

Description: Option
-
Quantity: 1
*1 GA700, GA800, CR700, and CH700 drives do not use the ground wire.
*2 GA700, GA800, CR700, and CH700 drives use two screws only.
◆

Installation Tools

• A Phillips screwdriver or slotted screwdriver (blade depth: 0.4 mm (0.02 in), width: 2.5 mm (0.1 in))
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
*1 Phillips screw sizes are different for different drive capacities.
8
for more information.
Table 3.1 Contents of Package
*1
Ground Wire Screws (M3)
1
LED labels
1000-Series
*2
3 1
YASKAWA SIEP C730600 86F MECHATROLINK-II Technical Manual
Installation Manual
GA500, GA700,
GA800, CR700, and
CH700
1 1
.
*1