Installing The Motor Housing; Installing The Blades - Hunter Bennett Series Installation Manual

1886
1
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
Insert grommets found in the
holes in the blades, then secure each blade to a blade iron
with screws found in the hardware bag.
Repeat x5
6
Ceiling Bracket Hanging Fan

Installing the Motor Housing

Notch
Indentation

Installing the Blades:

hardware bag into the
Wiring
2
With a Phillips head screwdriver, install
the four motor housing screws found in
the hardware bag. Tighten all four
screws securely.
Lightly attach the blade irons to the motor with
screws found in the
securely tighten after both screws are attached.
Motor Housing Blades
bag
bag
hardware bag, then
bag
Repeat x5
Light Remote
x4
Motor Housing
Screw
bag
x15
Blade Screw
x15
Grommet
x10
Blade Arm Screw
Troubleshooting