Hunter Bennett Series Installation Manual page 7

Remove the cardboard plug
guard before proceeding!
Connect the plugs from
the fan and light fixture.
Make sure to line up
the colored markings
on the connectors.
Need a little more help with assembling this light?
Visit our light kit video at:
Ceiling Bracket Hanging Fan
Assembling the Light
Push the connector and
excess wire into the hole at
the top of the light fixture.
IMPORTANT
The connector and excess wiring
must be pushed into the light
fixture in order to successfully
mount the light fixture to the fan.
HOLD HERE
http://bit.ly/HunterQuickConnect
Installing the Bulb and Glass
Lift the glass and attach it
to the light fixture using the
three thumbscrews. Tighten
all three screws securely
by hand.
Wiring Motor Housing
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
Some components not shown for visual clarity.
Hold the fan body stationary and rotate
the light fixture clockwise to engage the
locking pin.
Install the included bulb
into the socket. When
necessary, replace with
bulb of same wattage.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blades Light
Notch
ON
Remote Troubleshooting
1886
Pin
7