1886
The remote control is already paired for use.
with your remote.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
Fan Doesn't Work
• Make sure power switch is on.
• Check the circuit breaker to ensure the power is
turned on.
• Make sure the blades spin freely.
• Turn off power from the circuit breaker, then loosen
the canopy and check all the connections according
to the wiring diagram.
Excessive Wobbling
• Make sure the blades are properly installed on the
blade iron posts.
• Turn the power off, support the fan carefully, and
check that the hanger ball is properly seated.
• Use the provided balancing kit and instructions to
balance the fan.
Remote Control of Fan is Erratic
• Make sure the battery is installed correctly.
• Install a fresh battery.
8
Ceiling Bracket
Hanging Fan
Installing the Remote Control Cradle
For your convenience, a remote function card is packed in
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Troubleshooting
Remote Only Works Close to Fan
• Change battery.
Noisy Operation
• Make sure the blades are properly installed.
• Check to see if any of the blades are cracked. If so,
replace all of the blades.
Multiple Remote Issues
• If you have multiple remotes or multiple remote-
controlled fans installed on the same circuit breaker
and you are experiencing interference or faulty
operation of your remote controls, please go to
www.HunterFan.com/FAQs and click "How do I
properly install multiple remote-controlled fans?" for
information on how to correct this issue.
Wiring
Motor Housing
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Hunter Pro Tip:
Cleaning the Fan
Use soft brushes or cloths to prevent scratching.
Cleaning products may damage the finishes.
Blades
Light
Slide the cradle onto
the mounted bracket.
Remote
Troubleshooting