Table of Contents
Advertisement
1886
1
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
Insert grommets found in the
holes in the blades, then secure each blade to a blade arm
with screws found in the
hardware bag.
Repeat x5
5
Ceiling Bracket
Installing the Motor Housing
Notch
Screw Holes
Indentation
Screw Holes
Installing the Blades:
hardware bag into the
Hanging Fan
Wiring
Wiring the Fan
Connect the blue wire from
the receiver to the blue wire
(or possibly black with white
stripe wire) from the fan.
Connect the yellow wire
from the receiver to the
black wire from the fan.
2
With a Phillips head screwdriver, install
the four motor housing screws found in
the
hardware bag. Tighten all four
screws securely.
Blades
bag
bag
bag
bag
Light
Glass/Bulbs
x4
Wire Nut
x4
Motor Housing
Screw
x15
Blade Screw
x15
Grommet
Remote
Advertisement
Table of Contents
