Related Manuals for Hunter Bennett Series
Summary of Contents for Hunter Bennett Series
- Page 1 Bennett Collection Installation Manual Model: 50280 Matte Fresh White 53393 Matte Black 53394 Brushed Nickel Fan weight ±2 lbs: 20.3 lbs (9.2 kg) ©2019 Hunter Fan Co. M3647-01 r061819...
- Page 2 - All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 3 The screws below are drawn to scale to make it easier to identify what piece of hardware is needed to install each component. Hunter Pro Tip: Do not discard the hardware bags or mix parts from different bags. Make note of the symbol printed on each hardware bag.
-
Page 4: Choosing The Right Installation Location
31.8 kg (70 lbs) hardware bag. or less. Wood Screw Hunter Pro Tip: The machine screws are the ones that came with your outlet box. Ceiling Bracket Hanging Fan Wiring... -
Page 5: Hanging The Fan
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. Hunter Pro Tip: Here is how to connect the wires:... -
Page 6: Installing The Motor Housing
1886 Installing the Motor Housing Notch Motor Housing Screw Indentation Raise the motor housing up over the motor and ceiling bracket. Turn the motor housing so the screw holes align With a Phillips head screwdriver, install and the indentation in the housing locks into place with the four motor housing screws found in the notch in the ceiling bracket. - Page 7 1886 Assembling the Light Remove the cardboard plug guard before proceeding! Notch Push the connector and excess wire into the hole at the top of the light fixture. IMPORTANT Connect the plugs from the fan and light fixture. Make sure to line up The connector and excess wiring Raise the light kit to the bottom of the fan.
-
Page 8: Troubleshooting
Remote Control of Fan is Erratic • Make sure the battery is installed correctly. • Install a fresh battery. Hunter Pro Tip: Cleaning the Fan Use soft brushes or cloths to prevent scratching. Cleaning products may damage the finishes. -
Page 9: Limited Lifetime Warranty
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...