Installing The Motor Housing; Installing The Blades - Hunter 55079 Installation Manual

1886
1
Raise the motor housing up over the motor and ceiling
bracket. Turn the motor housing so the screw holes align
and the indentation in the housing locks into place with
the notch in the ceiling bracket. The motor housing is
not secured until the next step is complete. Do not
leave unattended.
Secure each blade to a blade iron as shown using the blade nuts, found in the
hardware bag, and the blade assembly screws, found in the
5
Ceiling Bracket Hanging Fan

Installing the Motor Housing

2
Notch
Indentation

Installing the Blades:

hardware bag.
Repeat x5
Wiring Canopy
With a Phillips head screwdriver, install
the four motor housing screws found in
the hardware bag. Tighten all four
screws securely.
Lightly attach the blade arms to the
motor with the blade arm screws,
then securely tighten after both
screws are attached.
Blades Light
Motor Housing
Screw
bag
Blade Screw
bag
Blade Nut
bag
x10
Blade Arm Screw
bag
Repeat x5
Remote Remote Cradle Troubleshooting
x4
x15
x15