Sidewinder Carrier - Toro Groundsmaster 3500 30807 Service Manual

Sidewinder Carrier

12
RIGHT
FRONT
1. Lower frame
2. Sidewinder carrier assembly
3. Slide bracket
4. Plastic slide
5. Flange head screw
Disassembly
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Remove lift arms (Fig. 18 and 20) (see Front and
Rear Lift Arms in this chapter).
3. Disassemble sidewinder carrier as needed (Fig. 21).
Wheels, Brakes, and Chassis
1
13
67 to 83 ft- lb
(91 to 113 Nm)
Figure 21
6. Flange nut
7. Cap screw
8. Thrust washer
9. Slide support bar
Page 7 - 22
2
10
10
9
8
7
10. Bearing cap
11. Lock nut
12. Lift arm (RH shown)
13. Lift arm pivot shaft
Assembly
1. Assemble sidewinder carrier using (Fig. 21).
A. Do not lubricate sidewinder cross tube as bearing
caps and slides are self lubricating.
B. Tighten the bearing cap screws from 67 to 83 ft- lb
(91 to 113 Nm).
2. Install lift arms (Fig. 18 and 20) (see Front and Rear
Lift Arms in this chapter).
6
11
8
4
4
3
5
Groundsmaster 3500