Toro Groundsmaster 3500 30807 Service Manual page 187

Removal (Fig. 86)
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove front lift cylinder from the frame and lift arm.
2. If hydraulic fittings are to be removed from lift cylin-
der, note and mark fitting orientation to allow correct as-
sembly.
Installation
1. If hydraulic fittings were removed from lift cylinder,
install fittings to cylinder using marks made during the
removal process to properly orientate fittings.
IMPORTANT: With lift arms raised fully, hydraulic
hoses should be routed as shown (Fig 87). Make
sure clearance between hydraulic hose and lift arm
is from 0.040 to 0.120 inches (1.0 to 3.0 mm). Do not
loosen hoses for repositioning without relieving
system hydraulic pressure first.
2. Install front lift cylinder to the frame and lift arm.
3. Make sure hydraulic tank is full. Add correct hydraul-
ic fluid if necessary.
4. Adjust front lift arms.
Groundsmaster 3500
2
1
1. Lift cylinder
2. Hydraulic hoses
Page 5 − 129
3
Figure 87
3. Clearance
Hydraulic System