Removal - Toro Groundsmaster 3500 30807 Service Manual

Removal

1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open and remove engine hood from the machine.
Slide seat all the way forward.
3. Disconnect both battery cables at the battery (see
Battery Service in Chapter 6 − Electrical System).
4. Disconnect air hose from the air cleaner and radiator.
Remove air cleaner assembly from the engine.
5. Remove muffler from the exhaust manifold and muf-
fler bracket (see Muffler Removal in this Chapter).
6. Drain radiator from the drain cock valve into a suit-
able container (see Radiator Removal in this Chapter).
Disconnect coolant hoses from the water pump and en-
gine block.
7. Remove coolant expansion tank and bracket from
the top fan shroud. Remove top fan shroud from the ra-
diator (see Radiator Removal in this Chapter).
8. Disconnect wire harness and electrical wires from
the following:
A. Battery, wire harness and engine grounds (Fig.
11).
B. Glow plug bus (Fig. 12) and fuel stop solenoid.
C. High temperature warning switch (Fig. 13).
D. High temperature shutdown switch, alternator,
and low oil pressure switch (Fig. 14).
9. Disconnect throttle cable from the support and swiv-
el on the speed control lever (Fig. 11).
10.Disconnect fuel hose from the fuel pump (Fig. 11)
and front injector nozzle.
11. Remove traction control cable from the neutral arm
assembly on the piston pump. Remove all hydraulic
hoses from the piston and gear pumps (see Piston
Pump Removal in Chapter 5− Hydraulic System).
12.Remove cable ties securing the wire harness to the
front lift tab and other engine parts. Connect hoist or lift
to the front and rear lift tabs (Fig. 12 and 13).
Groundsmaster 3500−D
6
1. Battery ground cable
2. Wire harness ground
3. Throttle cable
2
4
3
1. Glow plug wire
2. Rear injector nozzle
1. Temp. warning switch
1. Temp. shutdown switch
2. Alternator
Page 3 − 15
4
3
2
1
Figure 11
4. Support bracket
5. Speed control lever
6. Fuel hose
1
Figure 12
3. Fuel hose
4. Lift tab
2
1
Figure 13
2. Lift tab
1
2
3
Figure 14
3. Low oil press. switch
Kubota Diesel Engine
5