Removal; Installation - Toro Groundsmaster 3500 30807 Service Manual

Removal

Units prior to serial no. 314000001 use a separate hy-
draulic oil cooler. The hydraulic oil cooler on later units
is combined with the radiator assembly. It is not neces-
sary to drain the hydraulic system when removing the
radiator on early units prior to serial no. 314000001.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open and remove engine hood from the machine.
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns. Ethylene- gly-
col antifreeze is poisonous. Dispose of coolant
properly, or store it in a properly labeled contain-
er away from children and pets.
3. Place a suitable container under the radiator to col-
lect the coolant. Open drain- cock valve, and completely
drain the radiator.
4. Remove glow plug relay from the radiator assembly.
Position relay away from the radiator.
5. Place a suitable container under the hydraulic filter
to collect the hydraulic fluid. The container should have
a 6 gal. (23 Ltr.) minimum capacity. Disconnect the hy-
draulic hose below the filter head or remove the hydraul-
ic filter element and drain the hydraulic system (Fig. 9).
6. Disconnect following hoses from the radiator or radi-
ator/oil cooler assembly:
A. Upper radiator hose to the water pump.
B. Lower radiator hose to the engine block.
C. Coolant hose to the expansion tank.
D. Air hose to the air cleaner.
7. For units serial no. 314000001 & up, disconnect the
following hoses from the oil cooler section of the radiat-
or/oil cooler assembly:
A. Hydraulic tube from top of hydraulic fluid cooler.
B. Hydraulic hose from bottom of hydraulic fluid
cooler.
8. Remove expansion tank from the fan shroud.
Kubota Diesel Engine
CAUTION
1
1. Hydraulic filter element
2. Hydraulic filter head
9. Remove expansion tank bracket and both fan
shrouds from radiator assembly.
10.Remove flange head screws securing the top and
bottom of the radiator frame to the radiator. Remove four
carriage bolts and lock nuts securing the radiator to the
radiator frame.
11. Carefully remove radiator from the radiator frame.
12.Plug any openings to prevent contamination.

Installation

1. Remove any plugs used during the removal proce-
dures.
2. Position radiator carefully to the radiator frame.
3. Secure radiator assembly to the radiator frame with
four carriage bolts and lock nuts. Secure top and bottom
of radiator to frame with flange head screws.
4. Secure both fan shrouds to the radiator assembly
with flange head screws.
5. Secure expansion tank bracket and tank to the top
fan shroud with both flange head screws and flange
nuts.
6. For units serial no. 314000001 & up, connect the fol-
lowing hoses to the oil cooler section of the radiator/oil
cooler assembly:
A. Hydraulic tube from top of hydraulic fluid cooler.
B. Hydraulic hose from bottom of hydraulic fluid
cooler.
Page 3 - 12
2
3
Figure 9
3. Hydraulic hose
Groundsmaster 3500- D