Battery Service - Toro Groundsmaster 3500 30807 Service Manual

Battery Service

The battery is the heart of the electrical system. With
regular and proper service, battery life can be extended.
Additionally, battery and electrical component failure
can be prevented.
When working with batteries, use extreme cau-
tion to avoid splashing or spilling electrolyte.
Electrolyte can destroy clothing and burn skin or
eyes. Always wear safety goggles and a face
shield when working with batteries.
Electrolyte Specific Gravity
Fully charged: 1.265 corrected to 80
Discharged: less than 1.240
Battery Specifications
BCI Group Size 55:
540 CCA at 0F (−18C)
75 minute reserve capacity at 80F (27C)
Dimensions
(including terminal posts and caps)
Length 9.0 inches (22.8 cm)
Width 6.0 inches (15.2 cm)
Height 8.5 inches (21.6 cm)
Removal and Installation (Fig. 40 and 41)
IMPORTANT: Be careful not to damage terminal
posts or cable connectors when removing the bat-
tery cables.
1. Remove battery cover from the frame. Loosen bat-
tery retainer securing the back of the battery to the bat-
tery support.
2. Loosen and remove negative (−) cable from battery.
After negative cable is removed, loosen and remove
positive (+) cable from battery.
3. Carefully remove battery from machine.
4. Install battery in reverse order making sure to con-
nect and tighten positive cable to battery before con-
necting the negative cable.
Electrical System
CAUTION
o o
F (27 C)
1
1. Knobs
1
1. Ground cable
NOTE: Before connecting the negative (ground) cable,
connect a digital multimeter (set to amps) between the
negative battery post and the negative (ground) cable
connector. The reading should be less than 0.1 amp. If
the reading is 0.1 amp or more, the machine's electrical
system should be tested for short circuits or faulty com-
ponents and repaired.
5. Make sure that rubber boot is properly placed over
positive cable end and positive battery post.
Page 6 − 32
1
Figure 40
2. Battery cover
Figure 41
2. Positive cable
Groundsmaster 3500
2
2