Removal and Installation (Fig. 19)
1. Position the machine on a level surface, lower the
cutting decks to the floor, shut the engine off, and en-
gage the parking brake.
IMPORTANT: Support the cutting deck hydraulic
motor when removed from the deck. Do not allow
the hydraulic motor to hang from the hydraulic
hoses.
2. Disconnect and remove the hydraulic motor from the
deck (Fig. 20). Cover the top of the spindle to prevent
contamination.
3. Remove the lynch pin securing the deck carrier
frame to the lift arm pin (Fig. 21).
4. Roll the cutting deck away from the traction unit
Installation (Fig. 19)
1. Position machine on a level surface and shut engine
off.
2. Move cutting deck into position near lift arm.
3. Slide deck carrier frame onto lift arm pivot pin. Se-
cure with lynch pin (Fig. 21).
4. Install the hydraulic motor to the deck (Fig. 20). Make
sure that the O-ring is in position and not damaged.
5. Grease the spindle.
Groundsmaster 3500
1
1. Motor mounting screws
.
1. Lynch pin
Page 8 − 19
Figure 20
1
Figure 21
2. Lift arm pivot pin
Cutting Decks
2