Input And Output Signals - Citizen CBM-270 User Manual

7.3

Input and Output Signals

7.3.1 Input and Output Signals
(1) RXD
Serial received data signal.
data will be printed as "?".
(2) DTR
Write the data or a command when this signal is Ready.
ignored, resulting in an overrun error.
Busy is also issued at power-on, during test printing, at on-line, or at reset.
(3) TXD
If the remaining capacity of the input buffer comes to 128 bytes or less while receiving the data,
DC3(13H) will be output as a data not receivable signal.
or more, DC1(11H) will be output to the host side as a data receivable signal.
When sending the status information, it is confirmed that DSR is a space prior to sending the data, if
DTR/DSR control has been selected.
ignoring the DSR signal.
(4) FG
Ground for the case
(5) GND
Common ground for the circuits
If a framing error, overrun error, or parity error takes place, the relevant
The data can be written in the input buffer even during printing.
If DTR/DSR control has not been selected, the data will be sent,
24
CBM-270 User's Manual
If you write at Busy, the previous data will be
If the remaining capacity comes to 256 bytes
CITIZEN