Citizen CBM-270 User Manual page 63

ESC c 3
[Function] Selecting the paper near end sensor valid for a paper end signal output
[Code] <1B>H<63>H<33>H<n>
0 ≤ n ≤255
[Range]
[Outline] This command selects at which paper near end sensor a paper end signal should be output.
Each bit for n has the following meaning:
This printer can only select one kind of paper end detection, a paper-near-end sensor. n is
valid for the least significant bit (n0).
[Caution] This command is valid only for the parallel interface.
[Default] A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]
LPRINT CHR$(&H1B);"c3";CHR$(0);
LPRINT CHR$(&H1B);"c3";CHR$(1);
ESC c 4
[Function] Selecting the paper near end sensor valid for print stop
[Code] <1B>H<63>H<34>H<n>
0 ≤ n ≤ 255
[Range]
[Outline] This command selects at which paper near end sensor printing should be stopped.
for n has the following meaning:
This printer can only select one kind of paper-end detection, a paper-near-end sensor.
valid for the least significant bit (n0).
[Caution] If print stop is enabled, the printer will print (Feed the paper) 150 cm or an amount of data
specified with the ESC n command and go off-line.
[Default] A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]
LPRINT CHR$(&H1B);"c4";CHR$(0);
LPRINT CHR$(&H1B);"c4";CHR$(1);
n
Bit Position
0 Paper near end
∼
1 7 Undefined
••••••When outputting the paper-end signal at the paper end
••••••When outputting the paper-end signal at the paper near end
n
Bit Position
0 Paper near end
∼
1 7 Undefined
••••••When stopping printing at the paper end
••••••When stopping printing at the paper near end
(Parallel Interface Only)
Value
0
Disabled
Value
0
Disabled
48
CBM-270 User's Manual
1
Enabled
1
Enabled
Each bit
n is
CITIZEN