Citizen CBM-270 User Manual page 65

ESC n n
[Function] Setting a remaining amount of printout
[Code] <1B>H<6E>H<n>
0 ≤ n ≤ 255 ("n" in the 2nd byte denotes this command)
[Range]
[Outline] This command sets a print remaining amount after detecting PNE. n is set in units of cm.
[Caution] If the paper near end sensor is disabled, this command will not function.
print remaining amount are not cleared by the ESC @ command.
already set value is set at PNE detection time, the printer may stop printing.
remains valid until it is re-set or the printer is turned on again.
[Default] n = 150 (Remaining amount: 150 cm)
[Sample Program]
LPRINT CHR$(&H1B);"n";CHR$(100);
ESC t n
[Function] Selecting the character code table
[Code] <1B> H <74> H <n>
0 ≤ n ≤ 1
[Range]
[Outline] Selecting Page n on the character code table:
The character code table is selected depending on the value of n.
"n" means the followings.
[Caution] International character can not be changed.
Setting condition can be confirmed by self printing
[Default] An initial value of n is set to 1(Page 1) when the J1
[See Also] Character Code Table, ESC R
[Sample Program]
FOR N=0 TO 1
LPRINT CHR$ (&H1B) ; "t"; CHR$ (N) ;
LPRINT " n= " ; STR$(N) ; " " ;
FOR C=&HB1 TO &HB5
NEXT C
LPRINT CHR$ (&HA) ;
NEXT N
END
n
0 Page 0(IBM Character #2)
1 Page 1(Domestic Character)
the other cases, it is set to 0(Page 0).
LPRINT CHR$ (C) ;
••••••
When setting the print remaining amount = 100 cm
Condition
∼
3 are opened,
[Print Results]
50
CBM-270 User's Manual
The set value and
If a value lower than the
The set value
CITIZEN