Extron electronics DTP CrossPoint 108 4K Setup Manual page 14

D HDMI outputs (see
on page 5) — Plug HDMI video displays (or DVI with
appropriate adapters) into these ports. See
connectors
LockIt HDMI Cable Lacing Bracket.
The following table identifies the HDMI outputs by matrix size.
NOTE:
E
TP (XTP/HDBT/DTP) switches (see
ATTENTION:
The following table identifies the outputs with TP switches by
matrix size.
XTP position — Select if the receiving device is an Extron
XTP matrix switcher. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
HDBT position — Select if the receiving device is a
HDBaseT-enabled device. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
DTP position — Select if the receiving device is an Extron DTP
device. The TP output consists of HDMI with embedded audio,
analog audio, RS-232 and IR, and remote power.
F TP outputs (see
compatible Extron DTP receivers, XTP matrix
switchers, or HDBaseT-enabled devices into these
RJ-45 ports using TP cables. See
page 12 to wire the connector.
NOTE:
6 DTP CrossPoint 4K Series • Installation
figure 2
to secure the connectors to the enclosure with a
Matrix Outputs
10x8 1, 2, 3, 4, 5A, 6A
8x4 1, 2, 3A, 4A
The signal output on the nA HDMI output (such as
5A) is duplicated on TP output nB (such as 5B).
Position this switch BEFORE connecting the
•
appropriate device to the TP connector. Failure
to comply can damage the endpoint.
Positionnez le sélecteur AVANT de connecter
•
l'appareil approprié au connecteur TP. Ne
pas respecter cette procédure pourrait
endommager le point de connexion.
Matrix Outputs
10x8 5B, 6B, 7, 8
8x4 3B, 4B
figure 2
The signal output on the nB TP output (such as 5B)
is duplicated on HDMI output nA (such as 5A).
figure 3
on page 4 and
HDMI
Matrix
8x6
8x2
figure 2
Matrix
8x6
8x2
and figure 3) — Plug
TP connectors
Outputs
1, 2, 3A, 4A
1A, 2A
and figure 3) —
XTP
DTP HDBT
Outputs
3B, 4B, 5, 6
1B, 2B
SIG LINK
OUT
on