Assigning A Logo To An Output; Viewing And Adjusting Volume And Mic Volume - Extron electronics DTP CrossPoint 108 4K Setup Manual

Assigning a Logo to an Output

The switcher can display a logo on one or more of the scaled outputs.
The following table identifies the TP outputs by matrix size.
Matrix
10x8
8x4
NOTES:
•
•
1. Press and release the Logo
Lit input buttons identify saved logo files.
2.
Press and release the input button for the desired logo file.
The button blinks to indicate the selection.
3.
Press and release one or more output buttons to assign the
logo to those outputs.
The buttons indicate the selection.
4.
Press and release the

Viewing and Adjusting Volume and Mic Volume

Rotate the applicable knob clockwise
to increase the program volume or mic
volume. Rotate the knob counterclockwise
to decrease volume.
The LED ladder indicates the approximate
volume; the more LEDs are lit, the higher the volume.
Outputs
5 through 8
3 and 4
The switcher has memory space for 16 bit-mapped logo files.
Logos are created and saved using the Product Configuration
installing and Starting the Control Programs
Software (see
on page 28 and the PCS Help file).
LOGO
SELECT
Press and release.
1 2 3 4
3
5 6
ENTER
DTP CrossPoint 4K Series • Front Panel Operations
Matrix
8x6
8x2
button.
Select
LOGO
SELECT
The button lights.
INPUTS
5 6 7
Blinking indicates the need
to confirm the assignment.
button.
Enter
Outputs
3 through 6
1 and 2
MIC VOLUME VOLUME
)
19