Avaya 3600 Series Configuration And Administration Manual page 61

Ccms ip and call server with ip telephone emulation
Hide thumbs Also See for 3600 Series:
Table of Contents

Advertisement

Avaya, Inc.
Message
Resource
Gatekeeper rejected registration
Unavailable
request from the WT
Retarting...
The WT is in the process of
rebooting. There will be a 20 second
delay in an attempt to let potential
network/system errors clear.
Retry / Restart
The Wireless Telephone is waiting
for user input prior to retrying the
registration process, or restarting
after a delay.
Select License
The correct protocol has not been
selected from the license set.
Server Busy
WT is attempting to download from a
TFTP Server that is busy
downloading other devices and
refusing additional downloads.
SKT Open Failed
Socket open fail. Occurs when the
WT tries to connect to the PBX but
there is no response. If resiliency is
active, the WT will keep trying.
Socket Failure
WT cannot communicate with the AP
or the AVPP
Storing Config
WT is storing changes to handset
configuration.
AVPP Service Rej.
The AVAYA AVPP has rejected a
request from the WT
System Busy
y...y = AVPP IP Address
yyy.yyy.yyy.yyy
AVPP has reached call capacity.
System Busy
Avaya Voice Priority Processor is
busy or out of resources
System Error
An internal failure has occurred in
the Avaya Call Server.
21-300352, Issue 2, July 2005
Configuration and Administration—AVAYA 3616/3620/3626 WT
Avaya CCMS IP, Avaya Call Server, with Avaya 4612 IP Telephone Emulation
Description
Action
Check the H.323 gatekeeper
configuration in the WT.
Verify the gatekeeper or PBX's
configuration
None
See Avaya Call Server Integration
Factors section.
Using the administrative menus,
select one license from the set to
allow the WT to download the
appropriate software.
None, the WT will automatically
retry the download every few
seconds.
If the PBX is inoperative and
resiliency is not active or the WT
cannot locate a backup PBX, turn
off the WT and repair the primary
PBX. Note that it may be advisable
to reconfigure the backup PBX to
be the primary PBX if the repair is
more time-consuming than the
reconfiguration.
This message may display with
another diagnostic message.
Follow diagnostic actions for the
second message (such as No Net
Found).
None. Informational only. The
handset may display this briefly
following a configuration change or
software download.
The WT will restart and attempt to
re-register with the AVPP, which
should fix the problem. Report to
your administrator if it keeps
happening.
All call paths are in use, try the call
again in a few minutes.
All call paths are in use, try call
again in a few minutes.
If this condition persists, contact
the Avaya system administrator.
Page 61

Advertisement

Table of Contents
loading

This manual is also suitable for:

4612361636203626

Table of Contents