Range Cleaning - Thermador PD304 Care And Use Manual

SECTION SIX: CARE AND MAINTENANCE

Range Cleaning

WHEN CLEANING THIS RANGE:
1. Use the mildest cleaning procedure
that will do the job efficiently and
effectively. Some cleaners of the same
type are harsher than others. Try on a
small area first.
2. Always rub metal finishes in the direction of the polish lines for
maximum effectiveness and to avoid marring the surface.
3. Use only clean soft cloths, sponges, paper towels, fibrous brushes,
plastic, non-metal or steel wool soap pads for cleaning and scouring,
as recommended on the chart.
4. Any part of this appliance can be cleaned with hot sudsy water.
When rinsing is required, rinse thoroughly.
5. Always wipe dry immediately to avoid water marks.
COOKTOP CLEANING RECOMMENDATIONS
Cooktop Part / Material
Brass Burner Base
and Cast Iron Cap
Burner
Base
Burner
Cap
Star ® Burner
Components
Control Knobs / Plastic
Bezels / Chrome
Please see Guide to Knob
Identification and Location
on Page 11.
CAUTION
Avoid cleaning any part of
the range while it's hot.
Suggested Cleaners
• Hot sudsy water; rinse and dry
thoroughly.
• Mild Abrasive Cleansers: Bon
® ®
Ami , Cameo Aluminum and
Stainless Steel Cleaner,
®
Wright's All Purpose Brass
Polish.
• Liquid cleaners: Kleen King
• Stiff nylon bristle tooth brush
to clean port openings.
• Reassemble as shown. Make
sure that the burner cap is
seated on the base.
• Hot sudsy water; rinse and dry
immediately.
36
BRAND NAMES
The use of brand names is
intended only to indicate a type
of cleaner. This does not
constitute an endorsement. The
omission of any brand name
cleaner does not imply its
adequacy or inadequacy. Many
products are
distribution and can be found in
the local markets.
It is imperative that all products
be used in strict accordance with
instructions on the package.
The following chart gives
directions for cleaning this range:
Important Reminders
• Acidic and sugar-laden
spills deteriorate the stain-
less steel. Remove soil im-
mediately.
• Do not scratch or gouge the
port openings of burner
cap.
® .
• Do not soak knobs.
• Do not force knobs onto
wrong valve shaft.
Continued
regional in