Cleaning Tips; Range Cleaning - Thermador PRG364JDG Use And Care Manual

To Set Self-Clean Oven
1. Remove oven racks.
2. Ensure oven door is shut.
3. Select SELF CLEAN using the Mode Selector Ring.
4. Set Temperature Selector Knob to CLEAN.
-- Oven latch moves to secure the door.
-- Cooling Blower turns on.
-- The temperature gauge moves to CLEAN after five
minutes.
-- Display screen will indicate time remaining.
NOTE:
T
he door closing process takes approximately 20 seconds
to complete, at which time the door becomes locked.
Check to make certain the door is locked.
At the End of the Clean Cycle
The Clean cycle takes 2 hours to complete. Do not turn
either of the oven control knobs to the OFF position until
the automatic lock cycles to the open position.
1. Select OFF using the Mode Selector Knob.
• The door latch will open automatically when the
oven is below 500°F (260°C) and the automatic
Door Lock completes its 20 second cycle to the
open position.
• The cooling blower turns off when the oven
temperature drops to 375°F (191°C).
2. Turn Oven Control Knob to OFF position.
Prevention of Successive Self-Clean Cycles
The ovens are programmed to prevent initiation of a
second Self-Clean cycle for a period of 24 hours. All of the
other functions are available immediately after completion
of Self-Clean.
CAUTION!
The interior of the oven will still be at baking
temperatures when the automatic lock cycles to its open
position and the oven door can be opened.

Cleaning Tips

1. The porcelain enamel finish is acid resistant, but not
acid proof. Acidic foods, such as citrus juices,
tomatoes, rhubarb, vinegar, alcohol or milk, should be
wiped up and not allowed to bake onto the porcelain
during the next use.
2. Remove the oven racks. See Racks, on Range
Cleaning Recommendations.
3. The infrared broil burners in the oven(s) do not
require cleaning; the broil burners burn themselves
clean when the oven is in use.

Range Cleaning

When Cleaning This Range:
1. Use the mildest cleaning procedure that will do the job
efficiently and effectively. Some cleaners of the same
type are harsher than others. Try on a small
inconspicuous area first.
2. Always 1rub metal finishes in the direction of the polish
lines for maximum effectiveness and to avoid marring
the surface.
3. Use only clean soft cloths, sponges, paper towels,
fibrous brushes, plastic, non-metal or steel wool soap
pads for cleaning and scouring, as recommended on
the chart.
4. Most exterior parts of this appliance can be cleaned
with hot sudsy water (except the various items
specifically identified otherwise). When rinsing is
required, rinse thoroughly.
5. Always wipe dry immediately to avoid water marks.
6. DO NOT USE CHLORINE BASED CLEANERS.
CAUTION!
Avoid cleaning any part of the range while it is hot.
Brand Names
The use of brand names is intended only to indicate a type
of cleaner. This does not constitute an endorsement. The
omission of any brand name cleaner does not imply its
adequacy or inadequacy. Many products are regional in
distribution and can be found in local markets. It is
imperative that all cleaning products be used in strict
accordance with the instructions on its package. The
following chart gives directions for cleaning this range.
English 37