Table of Contents
Advertisement
17
• SHOULD A FLASHBACK FIRE OCCUR
IN OR AROUND THE BURNER TUBES,
FOLLOW THE INSTRUCTIONS BELOW.
FAILURE TO COMPLY WITH THESE
INSTRUCTIONS COULD RESULT IN A
FIRE OR EXPLOSION THAT COULD
CAUSE SERIOUS BODILY INJURY,
DEATH, OR PROPERTY DAMAGE
• SHUT OFF GAS SUPPLY TO THE GAS
BARBECUE
• TURN THE CONTROL KNOBS TO OFF
POSITION
• OPEN THE BARBECUE LID.
PUT OUT ANY FLAME WITH A FIRE
EXTINGUISHER
• ONCE THE BARBECUE HAS COOLED
DOWN, CLEAN THE BURNER TUBES
AND BURNERS ACCORDING TO THE
CLEANING INSTRUCTIONS IN THIS
OPERATOR'S MANUAL.
CAUTION: If burners go out during operation, close gas
supply at source, and turn all gas valves off. Open hood
and wait 5 minutes before re-attempting to light (this
allows accumulated gas fumes to clear).
CAUTION: Should grease fire occur, close gas supply at
source, turn off all burners and remove food until fire is
out.
KEEP THE VENTILATION OPENINGS OF THE
CYLINDER ENCLOSURE FREE AND CLEAR FROM
DEBRIS.
F
A
U
L
T
F
I
N
IF THE BARBECUE FAILS TO LIGHT
1.
Turn gas off at source and turn burner control
knobs to 'OFF'. Wait at least five (5) minutes for
gas to clear, then retry.
2.
If your barbecue still fails to light, check gas supply
and connections.
3.
Repeat lighting procedure. If your barbecue still
fails to operate, turn the gas off at source, turn the
control knobs to 'OFF', then check the following:
•
Misalignment of burner tubes over orifices
Correction: Reposition burner tubes over orifices.
•
Obstruction in gas line
Correction: Remove fuel line from barbecue. Do not
smoke! Open gas supply for one second to clear
any obstruction from fuel line. Close off gas supply
at source and reconnect fuel line to barbecue.
•
Plugged orifice
Correction: Remove burners from barbecue by
pulling cotter pin (beneath burner) using long nose
pliers. Carefully lift each burner up and away from
gas valve orifice. Remove the orifice from gas valve
and gently clear any obstruction with a fine wire.
Then reinstall all orifices, burners, cotter pins and
cooking components.
If an obstruction is suspected in gas valves or
manifold, contact your place of purchase or
manufacture.
•
Obstruction in burner tubes
Correction: Follow the burner tube cleaning procedure
on page 20 of this operator's manual.
•
Misalignment of igniter on burner
Correction: Check for proper position of the elec-
trode tip as shown on page 12. The gap between
the spark electrode tip and spark receiver should be
approximately 4 - 5 mm. Adjust if necessary.
With the gas supply closed and all control knobs set
to 'OFF' press the electronic igniter cap and check
for the presence of a spark at the electrode.
•
Disconnected electronic wires
Correction: Inspect the igniter junction box found
behind the control panel. Connect loose electronic
wires to junction box and try to light the barbecue.
•
Weak AA battery
Correction: Unscrew the igniter cap and replace the
battery.
D
I
N
G
17
Advertisement
Table of Contents
