Table of Contents
Advertisement
Panel Descriptions
Front Panel
No.
Name
1
INPUT connector
2
OUTPUT connector
[REAC MODE] switch
3
REAC MODE indicator
[MODE] switches
4
SAMPLE RATE indicator
[MUTE ALL OUTPUTS] button
5
MUTE ALL OUTPUTS indicator
8
1
Explanation
Various input devices are connected to these. The inputs include a variable-gain preamp that can accept signals
from -65 through +10 dBu (nominal, maximum input: +28 dBu).
The status of the connectors is displayed on 3 indicators.
CLIP
Lights in red when the input signal exceeds 0 dB (digital full scale).
SIG
Lights in green when the input signal is greater than -40 dB.
+48 V
Lights in orange when +48 V phantom power is supplied from the channel.
MEMO
You can adjust preamp gain and set phantom power on or off by remote control from an S-4000R unit or a
computer.
These are balanced male XLR connectors. Amps and powered speakers are connected here. The signal level that is
output is +4 dBu (nominal, maximum output: +22 dBu).
This sets the REAC's operation mode.
For the correct operation of the system, the mode settings of REAC devices must be made correctly. Making the
wrong settings may result in incorrect audio input and output.
M
The unit functions as a REAC master device.
S
The unit functions as a REAC slave device.
SP
The unit functions as a REAC split device.
NOTE
When changing the setting of the [REAC MODE] switch, first turn off the power to the S-2416.
The mode is set according to the state of the switch at startup, and so changing the switch setting once the unit
is running does not change the mode.
The indicator lights up when communication with the connected REAC device is established.
It flashes during standby.
These set the operation mode of the S-2416. For details, refer to "[MODE] Switches" (p. 10).
This displays the sampling rate at which the unit is operating.
This mutes (silences) the system's global audio output.
When the unit is muted, you can disconnect and connect input/output or REAC cables without producing noise.
When this is pressed, all output is muted within a second or two.
Releasing the button cancels muting.
2
3
4
5
7
8
6
9
10
11
Advertisement
Table of Contents
