Before Installing; Changing Where The Rack-Mount Angles Are Attached; Attaching The Rubber Feet - Roland Digital Snake S-2416 Owner's Manual

Before Installing

Changing Where the Rack-Mount Angles Are Attached

• You can shift the location where the rack-mount angles are installed by 16 millimeters.
• Attaching the rack-mount angles at the back lets you change the orientation in which the unit is mounted on a rack.
NOTE
Before carrying out this operation, detach all connections.
1.
Remove the rack-mount angle mounting screws (8) and detach the rack-mount angles.
2.
Using the screws (8) removed in step 1, attach the rack-mount angles.
* Be sure to use the screws removed from the unit to secure the angles in place. Using different screws might cause damage to the unit or
malfunction.
Shifting the mounting location by 16 mm

Attaching the Rubber Feet

Attach these as required, such as when you're using the S-2416 without mounting it on a rack or the like.
Peel off the double-sided tape from the rubber feet and affix the rubber feet at the locations shown in the following figure.
* When turning the unit over, handle the unit carefully; do not drop it.
Attaching at the back
7