Table of Contents
Advertisement
[2] Panel Description
@ Channel Equalizer Knob
This Knob controls the tone of the input signal. At 0, a
a.
2
a.
HIGH
: Adjusts the upper range. With 10 kHz as the center
aes eee :
frequency, adjustment can be made within the
5
SENS. 228 i
range of +15 GB.
"soon
:
LOW : Adjusts the lower range. With 100 Hzas the center
|
frequency, adjustment can be made within the
ia
a
)<
(3)
range of +15 aB.
dB)
|
7
y
20
EFF —o)-[AUK} | -
ail
vO. -Z)-
P A N
" (
a4
TTT,
i
val Ue
|
(1 Peak Signal Indicator
3
:
When a signal is fed into an Input Jack, the Peak Signal
Indicator willbe green. When the input signal level is too
1
high, the indicator will be red. The indicator willbe green
when the signal is at -20 dB of the rated level (after
passing the input sensitivity circuit) and red at-6dBof
20 iit
the
clipping
level.
;
20
50
100
200
500
Tk
2k
Sk
10k
= 20k
(Hz)
The Peak Signal Indicator also indicates signal level
® Effect Volume
from the Channel Insert or that have passed the
Effect Send.
Channel Volume; one portion is sent to the Effect
This knob will control the input sensitivity (depending
Volume, the other is sent to the Master Out.
on the level of the input signal). Set this so that Peak
Signal Indicator will become constantly green and red
during input peaks. If the Peak Signal Indicator do not
@ AUX Volume
light at all, raise the Sens Control Knob or increase the
input level.
This knob sets the level of the signal sent to the AUX
Send and the position where the signal is split. When
this knob is set to the center position, the signal level is
zero for both PRE signal(signal before being sent to the
Channel Volume) and POST signal(signal after the
Channel Volume). Rotating the knob clockwise will
adjust
the
POST
signal,
while
rotating
it
counterclockwise will adjust the PRE signal.
* The rated input is -60 dBm to +4 dBm.
©) Panpot
This knob controls the placement of the sound in the
stereo image (L+R). At the center position, the sound is
in the center of the field.
@ Channel Volume
This knob controls the level of the signal sent to each
channel.
,
* Channel Volume "10" is the rated output.
Advertisement
Table of Contents
