Names And Functions Of Each Part; Front Panel - Roland CPM-300 Owner's Manual

Names and Functions of Each Part
Front Panel
3 3
LY TE ES YS
000000000000§
EStbpaaesece
0900060000000
of
a
—_ =
=
13
Channel Section
Input Channels
1-6 (MONO)
7-8, 9-10 (STEREO)
1.SENS Knob
This adjusts the sensitivity to ensure the proper input signal level. Adjust this knob so that the PEAK indicator (6)
does not light too frequently.
* Rated Input Level Channel 1-6: +4 dBm to -60 dBm
Channel 7-8, 9-10: +4 dBm to -20 dBm
2.EQ (Equalizer) Knob
Use these to adjust the tone quality of the input signal. Setting a knob to the 0 position provides a flat response. (>
p. 12)
3.SEND Knob
This adjusts the output level of the signal sent to the Master section SEND knob (9).
* Output is normal when the knab is set to the 0 position.
* This signal is output after passing through the channel fader (post-fader). (Refer to the Block Diagram — p. 22,
4.PAN (Panpot) Knob
This knob assigns the left-right distribution of each channel's output, localizing the sound within the stereo field. At
center position, sound is localized at the center of the field (i.e., both the left and right channels are output at the
same volume).
5.BAL (Balance) Knob
This adjusts the left-right balance of the output, adjusting the apparent location of the sound in the stereo field. At
center position, sound is localized at the center (the volume is the same in both the left and right channels).