To Enjoy Bi-Amp Sound - Technics SA-DA10 Operating Instructions Manual

SPEAKERS A, B
BI-WIRE
A
SPEAKERS
A B BI-WIRE BI-AMP
B
SPEAKERS
A B
C
TAPE MONITOR
24
RQT5518
TAPE MONITOR
BI-AMP
SPEAKERS
BI-WIRE
BI-WIRE
LOW IMP
SPEAKERS
A
Enjoying the sounds

To enjoy bi-amp sound

A
By using the bi-wiring feature of this unit to connect your
speakers, you are able to take advantage of two separate
amplifiers for the high frequency and low frequency ranges. This
enables more highly defined sound reproduction of the two ranges
thus producing high quality bi-amp stereo sound.
Ensure "BI-AMP" lights when [BI-WIRE] is
selected.
BI-AMP will turn off and the indicator will go out in the
following cases
¡ If any of the DSP sound modes are turned on.
¡ If DVD 6CH INPUT is selected.
Note
¡ Before pressing [BI-WIRE], connect speakers designed for bi-
wiring using bi-wiring connection.
¡ Do not select [BI-WIRE] if you have connected two sets of
speakers to the A and B speaker terminals.
B For front speakers with an impedance under 6
Press and hold [A] or [B] until "LOW IMP"
lights up on the display.
If even one of the speakers being used has an impedance under
6 , press and hold down either [A] or [B] for 4 seconds or more to
set the impedance on the main unit to LOW.
(Press and hold down once again for 4 seconds or more to turn it
off.)
Note that when "LOW IMP" is on, SPEAKERS A and B cannot
both be used at the same time.
To change speakers:
e.g. To use SPEAKERS B, press [A] ("Å" goes out), and then
press [B] to activate SPEAKERS B.
C
To use TAPE MONITOR
{For use when you have connected a graphic equalizer to the
TAPE/MD (for the United Kingdom) or TAPE (for Australia and
New Zealand) terminals.}
Press [TAPE MONITOR].
The "TAPE MONITOR" indicator lights and the tape monitor
comes on.
Sources other than TAPE/MD (for the United Kingdom) or TAPE
(for Australia and New Zealand) can still be selected with [INPUT
SELECTOR] while the "TAPE MONITOR" indicator is on.
Press [TAPE MONITOR] again to turn the tape monitor off.
(\ See "Making a recording" on page 48 for details on how to use
the tape monitor during recording.)
Note
¡ The tape monitor cannot be used when TV, DVD, or CD digital
input is being used.
¡ If you are using the tape monitor and you select a digital input
source, the tape monitor switches off.
¡ Depending on the settings on the graphic equalizer, there may
be some distortion.