To Operate The Receiver - Technics SA-DA10 Operating Instructions Manual

To operate the receiver

To switch between on and standby
To select an input source (except PHONO and VCR 2/
FRT-VCR 3) and switch the remote control to each
operation mode
To select DVD 6CH INPUT mode
To adjust the volume
To select the DSP sound modes
To turn SFC on and select the mode
To output a test signal
To select the speaker channel and adjust its output level
When an SFC mode is on
To change the surround channel delay time
To mute the sound level
To dim the display
To select "FM" or AM"
To select the desired channel sequentially
(Preset tuning)
To select the desired channel directly
(Preset tuning)
To select radio stations by frequency
(Direct tuning)
Note
¡ TAPE MONITOR cannot be controlled with the [TAPE] button.
¡ The remote control for Australia and New Zealand does not have
an [MD] button.
(a Page 26)
(a Page 22)
(a Page 23)
(a Page 19)
¡When the SURROUND or SFC modes are on
(a Pages 19 and 23)
You can adjust the level of the center and surround speakers and
the subwoofer.
¡When the STEREO mode is on
You can adjust the level of the subwoofer.
(a Page 23)
(a Page 37)
(a Page 37)
(a Page 29)
(Example: Channel 1)
1
(a Page 29)
(Example: Channel 10)
10/ENTER
-/-- 1
0
within 10 seconds
39
RQT5518