To Adjust The Tone Quality Seca Incins Seiaseyestusncosscwoinentivginastirersansiecuaniecnseiee; To Adjust The Sound Balance; To Mute The Sound Level 5; To Listen Through Headphonss - Technics SA-AX910 Operating Instructions Manual

Operation ie
© © PHONES Headphones
m © . {not included)
VOLUME
LOUDNESS
Basic operations
@ Turn BASS to adjust the low frequency sound.
® Turn TREBLE to adjust the high frequency sound.
To adjust the sound balance
Turn BALANCE to adjust the left/right sound balance.
To mute the'sound level
Press MUTING.
The message "MUTING ON NOW" runs repeatedly from right to
left across the display as long as the muting function is on.
Press once again to return to the previous volume level.
When the receiver is turned off, the muting operation will be
automatically cancelled.
To listen through headphones
@ Use VOLUME to reduce the volume level.
@ Connect the headphones.
Plug type: 6.3 mm (1/4 in.) stereo
© Use VOLUME to adjust the volume level.
If you do not want sound from the speakers, press SPEAKERS
buttons) and check the speaker indicator(s) goes out.
If a subwoofer is connected to your system, turn off power to it (or
the subwoofer amp you are using) or lower the volume to the
minimum level.
Avoid listening for prolonged periods of time to prevent hearing
damage.
To correct sound in case of low volume >
This button balances low volume sounds by boosting bass sound
pressure.
Press LOUDNESS.
The message "LOUDNESS" will appear on the display, followed
shortly thereafter by the current setting "OFF". (O -©
Pressing the button again within 4 seconds will turn loudness con-
trol ON. When ON, "W" indication will light up in the display.
@-@)
To return to the previous condition, press once again, then "Il"
indication turn off,
When using the VCR 2 terminals (front side)
SA-AX910/AX810 only
This button can be used only when TV/VCR 2 is selected as the
input source.
The TV/VCR 2 input select button works for both TV input and
input from the source connected to the front side "VCR 2" terninals.
(See page 7)
Press TV/VCR 2 (ΠTV -= VCR 2) to set to the desired
position.
The display will read as follows.
O m. "TV"
@ -m .... "FRT-VCR 2"