Rack Mounting Procedure - Sony PFV-L10 Installation Manual

1-6-2. Rack Mounting Procedure

Explains the procedure for rack mounting by Rack Mount
Kit RMM-10.
n
Fasten the screws at the tightening torque below.
Tightening torque: 120 x 10
1. Attach the rack brackets in the side panels of the unit
with the specified six screws.
n
Be sure to use B4x6 as a screw.
Rack bracket
B 4x6
2. Loosen the screws at the rear of the each adaptor,
before adjusting each adaptor length to the rack depth.
(Following figure is case of left side.)
Rail portion
n
The maximum depth of an adaptor is 750 mm.
The minimum depth of an adaptor is 595 mm.
PFV-L10
_2
N.m {12.2 kgf.cm}
B 4x6
Rack bracket
B 4x6
(Length adjustment
screws)
3. Firmly lay the right and left adaptors in the rack with
the specified six screws.
(Following figure is case of left side.)
Front
Rear
2U
4. Fasten the length adjustment screws which are loos-
ened in step 2.
5. Align the crook of the each rack bracket on the side
panels of the unit with the rail, then slide the unit
backward.
n
Each rack bracket covers the rails as shown in the
figure below.
Rack bracket
Rail
6. Fix the unit to the rack with the specified screws and
ornamental washers.
Ornamental washer
RK 5x16
1-6. Rack Mounting
31.75
B 4x10
B 4x10
31.75
Rack bracket
Rail
Ornamental washer
RK 5x16
1-7 (E)