Sony PFV-L10 Installation Manual page 11

Installing Connector Panel (Rear side)
The connector panel must be installed to the slot which
contains the main board.
1. After removing the two screws, remove the blank
panel of the slot which contains the main board.
n
Keep the blank panel which is removed.
B 2.6x4
Blank panel
2. Connect the connector panel to the MB-862 board.
3. Secure the connector panel with the two screws
securing the blank panel.
B 2.6x4
Connector panel
n
Do not open the slot for an air-cooled effect of this unit.
Attach the blank panel to a empty slot.
PFV-L10
1-5. Installing Optional Board
1-5 (E)