電源ユニッ トB の電源が入る と緑色に点灯します。 次のよう な場合、赤く 点滅します。 電源ユニッ ト内の温度が規定以上に上昇した場合 換気用フ ァ ンが停止した場合 電源ユニッ トA のみが電源 ON の場合、 または電源ユニッ トB の 出力電圧に異常が生じた場合 電源負荷が規定以上に大きい場合。 POWER ( 電源ユニッ トB の電源をON/OFFします。 PFV-L10 INTERFACE UNIT -AC IN STATUS OUT AC IN 9 ∼ 端子 8 ∼ AC IN 端子...
仕様 電源電圧 AC 100 ∼ 120/220∼ 240 V、 50/60 Hz 消費電流 100 V:1.4 A、 240 V:0.58 A 供給可能電力 + 5 V DC 最大 13 A 使用温度 + 5 ℃∼ 40℃ 保存温度 − 20℃∼+ 60℃ 湿度 30 ∼ 70%(25℃) 最大外形寸法 440 ×88 × 353 mm (幅/高さ/奥行き) 重量...
Page 11
WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. THIS APPARATUS MUST BE EARTHED. AVERTISSEMENT Afin d’éviter tout risque d’incendie ou d’électrocution, ne pas exposer cet appareil à...
Page 12
For the customers in Europe This product with the CE marking complies with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European standards: •...
. When an optional board is installed in one of the slots, the power is supplied from the PFV-L10 to the board, and the functions of the board are activated. Select the appropriate optional boards and install them into the PFV-L10, allowing the unit to execute various signal- processing functions.
Page 14
Overview BKPF-L613C SDI Distributor with Analog Monitor Out (Component) This board distributes a component serial digital video signals to four outputs, and converts it to an analog signal for monitoring. BKPF-L632 Monitoring Composite Encoder Board This board converts a 4:2:2 component SDI signal to an NTSC or PAL composite analog video signal.
Page 15
• Only power unit A is turned on, or trouble occurs with the output voltage of power unit B. • A voltage load exceeds the specified level. 4 POWER B switch Turns on and off power unit B. PFV-L10 INTERFACE UNIT -AC IN STATUS OUT ~AC IN B connector...
Page 16
For signal ground. Connect to a ground wire as required. 7 STATUS OUT connector (15-pin) Outputs the following error statuses of the PFV-L10. • The inserted optional board does not function correctly. • The temperature inside the unit has risen to a specified level.
Page 17
Specifications Power requirements 100 to 120/220 to 240 V AC, 50/60 Hz Current drain 100 V: 1.4 A, 240 V: 0.58 A Peak inrush current (1) Power ON, current probe method: 20 A (100 V), 25 A (240 V) (2) Hot switching inrush current, measured in accordance with European standard EN55103-1: 18 A (230 V)