Viewfinder Indicators
aspect ratio 4:3
1
SAVE MENU BATT REC TAPE ND
SAVE MENU BATT REC TAPE ND
SAVE MENU BATT REC TAPE ND
31
31
2
3
4
5
-
+
++
-
-
+
+
++
++
Top indicators
1
BATT Function disabled.
REC
This red indicator lights to indicate that the
camera is on-air.
irregularity in the recording system occurs
(function depends on the type of recorder).
TAPE Yellow, when in triax (remote) mode: ISO-
indication.
RE
This green indicator lights when the range
extender is selected or toggles when a call
switch is used.
Safe area marker
2
Indicates the safe area which represents 80% of the
whole viewfinder picture area. This is the minimal
area which will be seen on a TV-set.
Centre marker
3
This cross marks the centre of the picture.
Cadre marker
4
These dotted white lines represent the limits of the
16:9 picture in the 4:3 mode and the limits of the 4:3
picture in the 16:9 mode. The area outside the cadre
will be cut off when the picture is displayed on a
monitor with an other format. The dotted lines can be
switched to a low contrast area, see Installation
Manual.
4-8
6
7
RE
RE
RE
F3.7
F3.7
f00
f00
9
8
AW2 AW1 3,2
5,6
AW2 AW1 3,2
AW2 AW1 3,2
5,6
5,6
It flashes when any
Operator's Manual LDK 23HS mkII - HS Camera System
aspect ratio 16:9
SAVE MENU BATT REC TAPE ND
SAVE MENU BATT REC TAPE ND
SAVE MENU BATT REC TAPE ND
-
-
+
+
++
++
AW2 AW1 3,2
AW2 AW1 3,2
-
+
++
AW2 AW1 3,2
Bottom indicators
5
The following green indicators light when:
-
gain is -
+
gain is +
++
gain is ++
AW2
colour temperature stored in memory position
2 is selected
AW1
colour temperature stored in memory position
1 is selected
3,2
colour temperature of 3200 K is selected
5,6
colour temperature of 5600 K is selected
Zoom indication
6
Indicates the degree to which the lens has been
zoomed in or out. This indicator only works when the
zoom signal is available from the lens.
Focus indication
7
Indicates where the lens has been focused. This
indicator only works when the focus signal is available
from the lens.
Zebra pattern
8
This diagonal line pattern warns the operator that the
area affected has risen above a predetermined level
of the full scale video exposure value. Level and range
are selectable via the menu control system.
Iris indication
9
Indicates the diafragm position. This indicator only
works when the iris signal is available from the lens.
Location of Controls and Functions
RE
RE
RE
5,6
5,6
5,6