Table of Contents
Advertisement
8
EN
Power Zoom Lever
START/STOP Button
PAUSE
Dioptre Adjustment Control
VMD22 EN(02/33)
Grip Adjustment
1
2
3
Lock Button
Viewfinder Adjustment
POWER Switch
MODE Dial
1
2
3
Tripod Mounting
1
8
GETTING STARTED
Separate the Velcro strip.
Pass your right hand through the loop and grasp
the grip.
Adjust so that your thumb and fingers can easily
operate the START/STOP Button and Power
Zoom Lever. Refasten the Velcro strip.
Set the POWER Switch to "
pressing down the Lock Button located on the
switch and set the MODE Dial to any position.
Pull out the viewfinder fully.
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Align the screw on the tripod with the camera's
mounting socket. Then tighten the screw.
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilise the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.
29/08/00, 14:40
(cont.)
" while
Advertisement
Table of Contents
