Shoulder Pad; Scriptboard - THOMSON LDK 23hs mkII Operator's Manual

Shoulder Pad

3
1
To mount another type of shoulder pad proceed as
follows:
a. Remove the two screws (1) securing the shoulder
pad to the camera.
b. Slide the lip (2) of the new shoulder pad under the
triangular bracket (3). Use the two screws (1) to
secure it in place.
Assembling the Units
2
Operator's Manual LDK 23HS mkII - HS Camera System

Scriptboard

3
To mount the scriptboard LDK 6985/15 onto the
camera proceed as follows:
a. Secure the scriptboard to the top-rear of the camera
with the retaining screw (1).
b. Connect scriptboard light cable to the scriptlight
connector (2) at the rear of the camera.
Caution
Ensure that the scriptlight does not
use more than 3W of power.
The scriptlight is switched on and off, and the intensity
is varied with the knob (3) at the rear of the scriptboard.
The retaining rings and clip (4) can be screwed onto
the right and left side resp. if required.
1
4
THS 1385
2
2-13