Making Power Connections - GE KTC-XP1 User Manual

KTC-XP1 UltraView Camera
2.4 M
AKING
CAUTION:
Use direct plug-in UL listed power supplies marked Class 2 or
LPS (limited power source) of the required output rating as listed
on the unit.
Complete all instruction steps before supplying power to the unit.
See Figure 5 and perform the following:
Figure 5. Power connections
1) With a screwdriver, loosen the ~AC24V/DC12V and GND terminal
screws on the terminal block.
2) Connect
a universal 12 VDC/24 VAC
Note: The terminal block is not polarity-sensitive. Either power lead can be
connected to either terminal connector.
3) Retighten the terminal screws until snug, ensuring that the power
leads are secure.
4) Supply power to the unit by plugging the power supply into a proper
power source.
Note: The power LED (
If it does not illuminate, check the terminal block connections and the power source.
1047441A / February 2004
P C
OWER ONNECTIONS
) illuminates to show that the camera is receiving power.
Connect a universal
12 VDC/24 VAC power
supply as shown
Note: The terminal block is not
polarity-sensitive.
Note: The power LED (
illuminates to show that the
camera is receiving power.
power supply to the terminal block.
Installation
)
9