GE KTC-XP1 User Manual page 19

KTC-XP1 UltraView Camera
To select a lighting environment
setting:
At the Main Menu, use the up and
down buttons (
the LOCATIONS option, use the
right and left buttons (
move to and between the options
(GENERAL, OUTSIDE, OFFICE,
and CUSTOM_WDR), then press
the center selection button (
select the option showing.
To adjust the bias and limit of the
custom WDR setting (if selected):
With CUSTOM_WDR still
highlighted, press the center
selection button (
WDR menu, use the up and
down buttons (
between the bias and limit
scales and use the right and left
buttons ( ) to adjust the
markers on the scales.
Note: Observe the results on the monitor screen for the best settings.
Note: Adjusting the bias changes the dynamic range of the camera's light meter. Reducing
the limit value lowers the maximum dynamic range of the camera. These values are best
left at their defaults: 0 bias and 12 limit.
Note: If the internal parameters of the camera end up differing from those set by the location
setting due to adjusting the default values, a location setting other than CUSTOM_WDR can
become CUSTOM_WDR.
Move to the PREVIOUS PAGE option and press
menu.
1047441A / February 2004
) to move to
) to
) to
). At the
) to move
MAIN MENU
CAMERA SETUP.
WHITE BALANCE
LOCATIONS
PTZ.
EXIT
WDR MENU
Bias dB
-36X
Limit dB
0
PREVIOUS PAGE...
(Bias default is 0; limit default is 12.)
to leave the current
Programming
ATW
<GENERAL>
SAVE CHANGES.
0 36
23 36
19