Sharp FO-2950M Operation Manual page 28

All manuals and user guides at all-guides.com
all-fo2950a.book Page 26 Thursday, March 23, 2000 5:38 PM
Setting Up the Multifunction Interface
2
Connect one end of the cable to the
port on the Sharp Laser Multifunction
fax. Snap the clips on each side of the
port onto the cable connector to
secure it.
3
Connect the other end of the cable to
the parallel port on the back of your
computer.
Note: There is normally no need to change the parallel port setting in
your computer's setup (BIOS) program. However, if you find that the
Sharp Laser Multifunction fax does not operate well when scanning or
printing, you may need to change the setting. In this case select ECP, PS2,
Bi-directional, or an equivalent parallel port mode.
26