Repeat; Setting The Repeat Interval; Repeat Setting The Repeat Interval - Tascam D00871320A Owner's Manual

Repeat

Repeat allows you to repeat the playback or auto-punched rehearsal
(see "Rehearsal" on page 32) between the IN and OUT points.
First, set the IN and OUT points at the place where you want the
repeat loop to start and stop (see "IN and OUT marks" on page 29).
Press the key briefly so that the indicator lights. Playback
REPEAT
starts automatically from the IN point.
When the playback reaches the OUT point, playback pauses for a
short while (see "Setting the repeat interval" on page 35) and the
indicator flashes before playback starts again, and the
lights steadily.
Turn off the repeat function by pressing
goes out.
Repeat auto-punch rehearsal, but not repeat auto-punch recording, is
also possible. If
AUTO PUNCH
to go from rehearsal to auto punch recording mode will also
RHSL
turn off .
REPEAT

Setting the repeat interval

You can set the time between repeats up to 9.9 seconds.
Press and hold the
shows:
Use the jog wheel to set the repeat interval from 0.5 seconds to 9.9 sec-
onds in 0.1 second steps.
Press again briefly to exit the interval setting mode.
REPEAT
REPEAT
, and
RHSL REPEAT
key for about a second, and the screen
REPEAT
Advanced techniques
PLAY
indicator
PLAY
so that the indicator
are all lit, pressing
TASCAM DP-01 Owner's Manual
You can't set these
points when
key is lit.
REPEAT
This repeat interval
allows you to repo-
sition your hands for a guitar lick,
take a breath for a vocal phrase,
etc., when you are rehearsing.
35
the