The Input Mode Switch; Figure 1.6: Rear Panel Connections - Tascam D00871320A Owner's Manual

Connecting your DP-01 to other equipment

The INPUT MODE switch

You will use this switch when you are recording from input A and
input B at the same time.
This front panel switch affects the way that you monitor the input signals,
both through the headphones and/or through the
are two positions:
—The signals from input
MONO x 2
center of the monitoring "stage".
—The signal from input
STEREO
from input is sent to the right of the monitoring "stage" forming a
B
stereo pair for use when you are recording stereo instruments such as
synthesizers, etc.
To MIDI sequencer,
drum machine, etc.
Power input and
switch
Monitoring and recording
jacks to connect the DP 01 to your monitoring system (that is, an amplifier/
speaker setup). When you're ready to make your final stereo master, you
can use these jacks to connect to an analog recorder.
A typical setup would connect these jacks to the AUX IN of a stereo sys
tem.
Use the stereo system's selector switch to listen to the AUX source when
tracking, bouncing or mastering on the DP 01.
When you have mastered the stereo track and you want to record it, set the
stereo monitoring system so that the recorder is set to record from the AUX
source. Now you are monitoring (or listening) through your stereo system.
Effect processor
When you want to use an external effect processor
with the DP 01, connect the rear panel
input of the processor (1/4" unbalanced jack).
Connect the stereo outputs of the processor to the two
DP 01 (1/4" unbalanced jacks).
18
TASCAM DP-01 Owner's Manual
LINE OUTPUT
and input are both sent to the
A B
is sent to the left, and the signal
A
To effects
To digital
unit
recorder, etc.

Figure 1.6: Rear panel connections

Use the rear panel
LINE OUTPUT
of the DP 01 to the mono
SEND
RETURN
jacks. There
recording at all—just the monitoring
process.
input signals are added together in
the center, and you may hear dis-
tortion in the monitoring system
This does not affect the recording,
though.
From stereo effects
unit outputs
To analog recorder,
monitoring system,
etc.
From sub-
mixer/MIDI tone
generator, etc.
RCA
the DP-01. "Mastering" means tak-
ing these recording tracks and mix-
ing them down to stereo.
own internal reverb processors.
However, you can also use an
jacks of the
external effect processor if you pre-
fer.
does
INPUT MODE
not affect the
In the
MONO X 2
mode, the and
A B
"Tracking" means
recording tracks on
The DP-01FX and
DP-01FX/CD their