Rack Mounting - Sony SR-R1000 Installation Manual

1-6. Rack Mounting

Explains how to mount this unit into a 19-inch standard
rack.
Be sure to mount this unit into a rack accurately following
the procedure and notes mentioned below.
w
. To prevent toppling over the rack, fi x it on the horizontal
and fi rm fl oor securely with bolts, etc.
. When installing the unit in an Outside Broadcasting van,
be sure to fi x the unit to the rack using the screws and
ornamental washers supplied with the rack mount kit.
c
. Use the specifi ed rack mount rail.
The use of other rail of low strength may drop the unit
and cause the risk of injury.
. Mount the unit into a rack with a steady posture.
m
. When other equipment with built-in hard disk drive is
already mounted in the same rack for mounting this unit,
turn off the power of the equipment before mounting this
unit.
. Connect long enough cables on the connector panel,
considering that the unit is pulled out from the rack.
. Do not operate this unit without the upper lid and bottom
plate except when servicing it.
. To suppress the internal temperature rise of the unit,
reserve a space of 4 cm or more on both sides and 15 cm
or more on the rear side between the rack and the unit.
(Refer to Fig. 1.)
To maintain ventilation in these spaces, open at least one
of the top, rear, right, and left faces at the rear of the unit.
(Refer to Fig. 2.)
. Adjust the temperature inside the rack within the range
of the unit's operating temperature.
(Refer to Section 1-3.)
SR-R1000
(Fig.1) (Fig.1)
(Fig.2) (Fig.2)
R i g R i g R i g R i g
4 cm or more 4 cm or more 4 cm or more 4 cm or more
15 cm or 15 cm or 15 cm or 15 cm or
more more more more
4 cm or more 4 cm or more 4 cm or more 4 cm or more
L e L e L e L e
f t f t f t f t
a r a r a r a r
R e R e R e R e
h t h t h t h t
1-5 (E)