Sony SR-R1000 Installation Manual page 15

Attaching inner rails
4. Pull the inner rails out of the middle rails.
5. Pull out the inner rails in the direction of arrow B
while pressing the stoppers of the inner rails in the
direction of arrow A.
Middle rail Middle rail
Inner rail Inner rail
Stopper Stopper
B B
6. Remove the 10 screws from the right and left side
panels of the unit as shown in the fi gure below.
7. Attach two inner rails to the right and left side panels
of the unit using the screws removed in step 6.
Tightening torque: 120 x 10
m
. Be sure to use B4 x 6 screws to secure the inner
rails. Using other screws may cause operational
problems to the unit.
. Do not install screws other than those for inner rail
fi xing screw holes that are used actually. If unneces-
sary screws are installed, the unit cannot be mounted
on the rack.
Inner rail Inner rail
B4 x 6 B4 x 6
n
When replacing a Sony's 5U-size VTR with this unit in the
rack, attach the inner rails at the lower part.
The bottom plate of this unit is at the same height of the
bottom plate of the 5U-size VTR.
SR-R1000
Outer rail Outer rail
A A
N . m {12.2 kgf . cm}
_2
B4 x 6 B4 x 6
Inner rail Inner rail
Attaching rack angles (handles)
8. Remove the four screws from the right and left side
panels of the unit.
B4 x 6 B4 x 6
B4 x 6 B4 x 6
m
. Keep the removed screws (B4 x 6) in a safe place.
. When removing the rack angles and attaching the
side panels directly with screws, be sure to use the
screws (B4 x 6) removed in step 8. Using other
screws may cause operational problems to the unit.
9. Attach the two rack angles to the right and left sides of
the unit with the four rack angle fi xing screws (with
stopper) supplied with the rack angles.
Tightening torque: 120 x 10
Rack angle Rack angle
B4 x 6 B4 x 6
N . m {12.2 kgf . cm}
_2
Rack angle Rack angle
1-7 (E)