Output Rectifier Bridge Removal And Replacement - Lincoln Electric EAGLE 10,000 Service Manual

F-44
TO POLARITY SWITCH
ENGINE
PROCEDURE
1. Remove the engine spark plug wires.
2. With a 5/16" nut driver, remove the 6 sheet
metal screws from the case top.
3. Remove the rubber gasket (cover seal) from the
lift bail.
4. Remove the fuel cap. The rubber gasket for the
fill tube will come off with the case top.
5. Remove the case top, then reinstall the fuel
cap.
6. With the 5/16" nut driver, remove the 5 screws
holding the right case side.
7. Remove the right case side by lifting up and
out.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
OUTPUT RECTIFIER BRIDGE REMOVAL
AND REPLACEMENT (continued)
FIGURE F.11 - OUTPUT RECTIFIER CONNECTIONS
(3) 1/2"
MOUNTING
SCREWS
NO NUT
EAGLE™ 10,000
#8
L1 TO CHOKE
(-)
(+)
(-)
(+)
(+)
(-)
For the remaining steps, refer to Figure F.11.
8. With a 1/2" wrench, remove the choke lead.
9. With the 1/2" wrench, remove the heavy cable
and the #8 lead (White) from the rectifier neg-
ative heat sink.
10. WIth a 7/16" wrench, remove the W1 lead and
the heavy lead going to the S2 Polarity switch.
11. With the 7/16" wrench, remove the S2 lead,
the heavy lead going to the S1 Range switch,
and 254 (White) lead to sense turroid.
W1
TO S2
(4) 7/16"
MOUNTING
SCREWS
TO S2
TO S1
254
F-44