Prerequisites
• Ensure you have a PVIM module ready to install before opening the chassis top cover.
• Ensure you have a Phillips #1 screwdriver.
• Ensure the AG2330 is powered off.
Procedure steps
1. Remove the AG2330 top cover. For information, see
2. Locate the internal PVIM module connector slot.
3. Release the latches that secure the PVIM in the slot. There is a release latch at both
4. Firmly grasp the edges of the PVIM and pull straight up to remove the PVIM from
5. Holding the replacement PVIM by its edges, insert the new module into the slot,
Replacing the AG2330 DDR2 SO-DIMM
Use the instructions in this section if you must replace the internal DDR2 SO-DIMM on the
AG2330. This internal device is not hot swappable.
Installation — Hardware Components
cover
on page 33.
See the following figure for reference.
ends of the PVIM slot.
the slot.
pushing down gently, but firmly, to fully seat the module.
The release latches close when the PVIM is properly installed.
Replacing the AG2330 DDR2 SO-DIMM
Removing the AG2330 top
August 2010
35