Related Manuals for Avaya Remote Gateway 911 Series
Summary of Contents for Avaya Remote Gateway 911 Series
-
Page 1: Quick Start Guide
Avaya Remote Gateway 911x Series Quick Start Guide Avaya Remote Gateway 911x Document Status: Standard Document Number: N0027496 Document Version: 1.1... - Page 2 Avaya does not guarantee that these links will work all the time and has no control over the availability of the linked pages.
- Page 3 Preface Congratulations on your purchase of the Avaya Remote Gateway 911x series unit. With the Avaya Remote Gateway 911x product you have the advantage of a full featured host PBX at your home office. This Quick Start Guide gets you up and running with your Avaya Remote Gateway unit.
- Page 4 4 Preface N0027496...
-
Page 5: Avaya Remote Gatewayinstallation
Standard 1.1 Avaya Remote GatewayInstallation You need a 10BaseT Ethernet cable to provide the Avaya Remote Gateway 911x series unit with voice over IP capability. For instructions on how to install a Remote Gateway 911x unit turn to “Installing the Remote Gateway 911x unit” on... -
Page 6: Installing Ferrite Beads
Avaya Remote GatewayInstallation Secure the circuit card to the footstand with the two screws provided. Plug the 18 cm (7 inch), TCM cable into the RJ11 jack on the telephone (the other end is attached to the Remote Gateway 9110 circuit card). -
Page 7: Installing The Remote Gateway 911X Unit
Connecting the Avaya Remote Gateway 911x series unit to the network To route calls over the IP network, or administer the Avaya Remote Gateway 911x series unit from another location on the IP network, connect the unit to the Ethernet network by doing the following: Plug one end of a 10BaseT Ethernet cable (with an RJ-45 connector) to the ETHERNET jack on the Remote Gateway 911x series unit. - Page 8 Avaya Remote GatewayInstallation To connect the Remote Gateway 911x series unit to the power source as follows: Connect the plug on the power transformer to the POWER connector on the Remote Gateway 911x series unit. Attach the power cord to the power transformer.
-
Page 9: Telephone Menu Keys
Standard 1.1 Configuration You can configure the Avaya Remote Gateway 911x series unit through the telephone set. The procedure is the same for either the Remote Gateway 9110 circuit card or 9115 unit. Before you begin, your System Administrator must supply you with a completed Remote Gateway 911x series telephone menu —... -
Page 10: Configuring The Avaya Remote Gateway 911X Series Unit
Release (Rls, R, or Goodbye depending on your telephone set) key once. Configuring the Avaya Remote Gateway 911x series unit After installing the Avaya Remote Gateway 911x series unit and powering up: Press the Release key four times within three seconds to access the telephone menu.