Fxo/Cama Small Module - Avaya Advanced Gateway 2330 Installation Manual

LED
LINK/STAT 3
(applicable to 4-
port module only)
LINK/STAT 4
(applicable to 4-
port module only)
Embedded LEDs
at the RJ11 ports

FXO/CAMA Small Module

The 2- and 4-port FXO/CAMA Small Modules are hot swappable modules.
If you are working with 2- or 4-port FXS/DID or FXO/CAMA Small Modules, ensure you read
the safety messages related to the FXS/DID and FXO/CAMA interface modules. See
Exchange Station/Direct Inward Dial (FXS/DID) Interface Modules
Exchange Office/Centralized Automatic Message Accounting (FXO/CAMA) Interface
Modules on page 8.
The FXO/CAMA Small Modules support only voice TDM connections. The FXO/CAMA Small
Modules provide voice interface access through each of the FXO/CAMA ports. The FXO/
CAMA Small Module represents the Customer Premises Equipment (CPE) side of a telephony
interface.
You can install the 2- and 4-port FXO/CAMA Small Modules in any of the Small Module slots
on the AG2330 chassis.
The following figure shows the 2-port FXO/CAMA Small Module.
Installation — Hardware Components
• Red: The port is not configured
• Green: A call is in progress
• Yellow: The port is configured and ready to accept calls
Status of interface 3:
• Red: The port is not configured
• Green: A call is in progress
• Yellow: The port is configured and ready to accept calls
Status of interface 4:
• Red: The port is not configured
• Green: A call is in progress
• Yellow: The port is configured and ready to accept calls
Activity at the interface:
• Red: The module is up, but the interface is not configured
• Amber: The interface is configured and ready to use
• Green: The interface has an active call
Interface modules for the AG2330
Description
Foreign
on page 7 and Foreign
August 2010 21