Problem
After the SmartLine ele-
ment has been
switched on appears
in the timer display for a
short while. The Smart-
Line element does not
heat up.
The Tepan plate or a
cooking zone switches
off automatically.
An operating noise can
be heard after the
SmartLine element has
been switched off.
The sensor controls
show increased sensit-
ivity or fail to react.
flashes alternately
with in the timer dis-
play and a tone will
sound.
Cause and remedy
The SmartLine element is in demonstration mode.
Touch the 0 and 2 sensor controls at the same
time until flashes alternately with in the
timer display.
It has been operated for too long.
Switch the Tepan plate or the cooking zone back
on (see "Safety switch-off").
The overheating protection mechanism has been ac-
tivated.
See "Overheating protection".
The cooling fan runs until the SmartLine element has
cooled down and then switches off automatically.
The sensitivity level of the sensor controls has
changed.
Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the Smart-
Line element. The area surrounding the SmartLine
element must not be too dark.
Take any pans off the SmartLine element and wipe
away any food deposits.
Ensure that there is nothing covering the entire
SmartLine element unit or sensor controls.
Interrupt the power supply to the SmartLine ele-
ment for approx. 1 minute.
If the problem persists after power has been re-
stored, please contact Miele Service.
The SmartLine element is connected incorrectly.
Disconnect the SmartLine element from the mains.
Contact Miele Service.
Problem solving guide
37